Gainesville summers are long, hot and sticky, and even in late fall there are plenty of warm, humid afternoons when the air conditioner is still doing real work. So when the AC quits, whether it is a July evening or a muggy November day, the house can get uncomfortable fast. The good news is that many breakdowns follow a familiar pattern, and knowing what to check and what to tell a technician can get your system running again sooner.
Aire Masters is a family-owned HVAC company that has served North Central Florida since 2007, including Gainesville and the rest of Alachua County. This guide walks through what to do in the first few minutes after your AC stops cooling, the most common causes we see, what a repair visit looks like and how to decide between repair and replacement. If your system is down right now and you would rather talk to someone, call (352) 414-6556.
First steps when your AC stops cooling
Before you call for AC repair in Gainesville, a few safe checks can either solve the problem or give the technician useful information:
- Look at the thermostat. Make sure it is set to cool, the set temperature is below the room temperature and the fan is set to auto. If the display is blank, replace the batteries if it uses them.
- Check the air filter. A filter packed with dust and pet hair can choke airflow so badly that the system barely cools or the coil freezes.
- Check the breaker panel. Look for a tripped breaker for the outdoor condenser or the indoor air handler. Reset it once. If it trips again, leave it off and call.
- Go outside and look at the condenser. On a cooling call, the fan on top should be spinning and you should hear the unit running. Clear away leaves, grass clippings and anything stacked against it.
- Look for water. A full drain pan, water near the air handler or a float switch that has shut the system off often points to a clogged condensate line.
- Check for ice. Ice on the copper line at the outdoor unit or on the indoor coil means the system needs to thaw before it can cool again.
If you find ice, turn the system off at the thermostat and let it thaw, or run only the fan for a while. Running a frozen system in cool mode can damage the compressor. Our posts on what to do when your AC freezes up and safely resetting your HVAC breaker cover those two situations in more detail.
Common reasons an AC quits in Gainesville homes
Every system is different, but most no-cooling calls trace back to a short list of causes. Florida heat and humidity are hard on all of them.
Electrical parts: capacitors and contactors
The capacitor gives the compressor and fan motor the boost they need to start. The contactor is the switch that turns the outdoor unit on and off. Both wear out with heat and constant cycling. A common sign is an outdoor unit that hums but will not start, or a fan that does not spin while the indoor blower keeps running.
Clogged condensate drain
Air conditioners pull a lot of moisture out of the air here, and that water drains through a small line. Algae and debris can block it, and many systems have a safety switch that shuts the AC off when the pan fills. The system may look dead even though nothing is broken.
Low refrigerant from a leak
Refrigerant is not used up like fuel. If the charge is low, there is a leak somewhere. Signs include weak cooling, long run times, a hissing sound and ice on the lines. Adding refrigerant without finding the leak only delays the problem. Our guide to troubleshooting refrigerant leaks explains what a proper leak check involves.
Dirty coils and restricted airflow
A dirty outdoor coil cannot release heat well, and a dirty indoor coil or a blocked return cannot move enough air. Either one makes the system work harder and cool less. Pollen, oak debris and lawn clippings are frequent culprits around Gainesville homes. See signs your AC needs coil cleaning for more.
Thermostat and control issues
Wiring problems, a failing thermostat or a bad control board can stop the system from getting the signal to run. These are usually quick to diagnose once a technician is on site.
Motor and compressor problems
Blower motors, condenser fan motors and compressors are the larger components. Grinding, screeching, burning smells or a unit that trips the breaker repeatedly can point to one of these. Shut the system off and call for service rather than letting it keep trying to start.
When to call for AC repair right away
Some problems can wait for a scheduled visit. Others are worth a call right away:
- The breaker trips again after one reset.
- You smell burning or see scorch marks near the unit or the air handler.
- The outdoor unit is buzzing loudly but not starting.
- Water is leaking into ceilings, walls or flooring.
- Someone in the home is elderly, very young or has a health condition that makes heat dangerous.
- The indoor temperature keeps climbing even though the system is running.
Aire Masters offers 24/7 emergency service. Our emergency AC repair tips post covers what to do while you wait for a technician.
What happens during an AC repair visit
A good residential AC repair visit is about finding the real cause, not just getting the system to run for the afternoon. A typical visit includes:
- Asking what you noticed: when the problem started, sounds, smells and any breaker trips.
- Checking the thermostat, wiring and the low-voltage control circuit.
- Testing the capacitor, contactor and electrical connections at the outdoor unit.
- Inspecting the condenser fan motor, coil and compressor operation.
- Checking the indoor blower, evaporator coil, drain pan and condensate line.
- Measuring refrigerant pressures and temperatures to see whether the charge is right.
- Checking airflow and the temperature drop across the system once it is running again.
When the diagnosis is done, you should get a clear explanation of what failed and what your options are, with time to ask questions before any work begins. If the issue is a worn part, many repairs are completed during the same visit.
Repair or replace in Gainesville?
There is no single answer for every home, but these questions help:
Repair usually makes sense when
- The system is relatively young and has been maintained.
- The failure is a single part, such as a capacitor, contactor, drain switch, sensor or fan motor.
- The house was cooling well and humidity was under control until now.
Replacement is worth discussing when
- The system is well into its second decade and breakdowns are becoming routine.
- There is a compressor failure or a leaking coil on an older unit.
- Some rooms never cool well, which may point to sizing or ductwork problems.
- The system uses an older refrigerant that is no longer produced, which makes refrigerant repairs harder.
If replacement makes sense, our AC installation and replacement team starts with a load calculation and a look at your ductwork so the new system fits the house. For additions, garages or rooms that never stay comfortable, a ductless mini split can be a good option.
Gainesville and Alachua County service
We work on homes and businesses across Gainesville, from neighborhoods near the University of Florida to homes throughout Alachua County. South of town we also serve Micanopy. Visit our Gainesville AC installation and repair page for an overview of the services we provide in the area, or see all of our service areas, including Ocala, The Villages, Summerfield, Dunnellon, Citrus Springs, Crystal River, Hernando and Silver Springs.
Businesses can reach the same team for commercial AC repair, and our technicians also handle heat pumps and heating repair now that cooler nights are here.
Preventing the next breakdown
Most of the breakdowns above give some warning before they leave you without cooling. A preventative maintenance visit cleans the coils, flushes the drain line, tests capacitors and contactors, checks the refrigerant charge and tightens electrical connections. Many Florida homeowners schedule maintenance twice a year, once before summer and once before winter. Between visits, change your filter regularly, keep the outdoor unit clear and pay attention to new sounds or longer run times.
Frequently asked questions
Why is my AC running but not cooling?
The most common causes are a dirty filter, a frozen coil, a low refrigerant charge from a leak, a dirty outdoor coil or an outdoor unit that is not running because of a failed capacitor or contactor. Check the filter and thermostat first, then call a technician if the system still is not cooling.
Why did my AC stop and the thermostat goes blank?
A blank thermostat can mean dead batteries, a tripped breaker, a blown fuse in the air handler or a float switch that shut the system off because the drain is clogged. Check the batteries and breakers, then look for water around the air handler.
Should I keep running my AC if it is making a loud noise?
No. Grinding, screeching or loud buzzing often means a motor or electrical part is failing. Turn the system off at the thermostat and call for service to avoid further damage.
Do you offer emergency AC repair in Gainesville?
Yes. Aire Masters offers 24/7 emergency service. Call (352) 414-6556 to reach our team.
What areas near Gainesville do you serve?
We serve Gainesville and Alachua County, including Micanopy, along with Ocala and Marion County, The Villages, Summerfield, Dunnellon, Citrus Springs, Crystal River, Hernando and Silver Springs.
Get your Gainesville AC running again
When your AC quits, you want a straight answer about what is wrong and what it will take to fix it. Aire Masters has been a family-owned HVAC company since 2007, and our technicians treat every home like it is their own. Call (352) 414-6556 or reach us through our contact page to schedule AC repair in Gainesville.


